Skip to content

niklasekstrom/clockport_pi_interface

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

21 Commits
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Amiga clock port to Raspberry Pi interface

This interface has a small 64 kB SRAM memory that is shared between an Amiga and a Raspberry Pi. The Amiga connects to the interface through the clock port.

The A314 software has been adapted to this interface so that it is possible to run services such as a314fs and the SANA-II network driver. This board has later become referenced to as A314-cp. The software for all variants of A314 is available in the main branch of the a314 repository. The instructions for how to install the software is in the Software/README.md file.

PCB Installed with Pi 3A
PCB

Details about how the interface works

Either side, the Amiga or the Pi, can read from and write to the SRAM. The interface is 8 bits wide, meaning that each access reads or writes one byte. The interface is symmetric between the sides, so in this description we describe how the Amiga is communicating with the interface, but the communicating between the Pi and the interface works in the same way.

The Amiga can perform two commands towards the interface:

  • Read a register
  • Write a register

The interface exposes four registers:

  • REG_SRAM = 0
  • REG_IRQ = 1
  • REG_A_LO = 2
  • REG_A_HI = 3

The interface has the following state variables:

  • Amiga address pointer, 16 bits
  • Pi address pointer, 16 bits
  • Amiga interrupt request, 1 bit
  • Pi interrupt request, 1 bit

The actions that the Amiga can do, and their effects:

  • Write REG_A_LO or REG_A_HI: update the Amiga address pointer.
  • Write REG_IRQ: write 0 to clear the Amiga interrupt request bit, and write 1 to set the Pi interrupt request bit.
  • Read REG_SRAM: reads and returns the byte in SRAM that the Amiga address pointer points to, and then increments the pointer.
  • Write REG_SRAM: same as above but writes a byte to SRAM and increments address pointer.

So in order to read and write to the SRAM, either side must set the address pointer, and then repeatedly read (or write) REG_SRAM in order to read (or write) subsequent positions in the memory.

Bill of materials

References Value Footprint Quantity
C1, C2, C3, C4, C5, C6, C7, C8 0.1u C_0603_1608Metric 8
U1 XC9572XL-VQ64 TQFP-64_10x10mm_P0.5mm 1
IC2, IC3 SN74LVC573APWRE4
(alt: 74LVC573APW,118)
SOP65P640X120-20N 2
IC1 IS63WV1288DBLL-10TLI
(alt: IS61WV1288EEBLL-10TLI)
SOIC127P1176X120-32N 1
J1 Raspberry_Pi_2_3 PinSocket_2x20_P2.54mm_Vertical 1
J2 Conn_02x11_Odd_Even PinSocket_2x11_P2.00mm_Vertical 1